X84; „ Display Condition Settings; Display Condition Settings - Konica Minolta CM-M6 Instruction Manual

2
Use [] or [] to move the cursor to "ON" or "OFF",
and then press the [Confirmation] key to turn the
function ON or OFF.
Selections
OFF : Disables the tilt detection function.
{ „
ON : Enables the tilt detection function.
{ „
3
Press the [Confirmation] key to confirm, and then
press [ESC].
The selection is confirmed and the screen returns to the
previous screen.
If [ESC] is pressed without pressing the [Confirmation]
Notes
key, the settings will not be changed and the screen will
return to the previous screen.

Display Condition Settings

„ „
To set display conditions, select "Observer/Illuminant" from the <Measurement cond.> menu screen.
The following two observer/illuminant settings can be configured for the display conditions.
• Observer/Illuminant 1: Select the observer/illuminant used to measure the colorimetric data.
• Observer/Illuminant 2: Select the secondary illuminant used for MI (metamerism index) calculation, etc.
Operating Procedure Start the procedure from the measurement screen.
1
Press [MENU], and then use [] or [] to display the
<Measurement cond.> menu screen.
To return to the previous screen, press [MENU] or [ESC].
Memo
2
Use [] or [] to move the cursor to "Observer/
Illuminant", and then press the [Confirmation] key.
The <Observer/Illuminant> screen is displayed.
3
After setting the observer/illuminant, press [ESC] to
return to the previous screen.
Sample
Measurement cond.
Measurement setup
Tilt detection
Tilt detection
OFF
OFF
ON
Sample
Measurement cond.
Measurement setup
Observer/Illuminant
Display cond.
Sample
Measurement cond.
Observer/Illuminant
Observer/Illuminant 1
10°/D65
Observer/Illuminant 2
None
3
72