Konica Minolta CM-M6 Instruction Manual page 86

2
Use [] or [] to move the cursor to the item to be
set, and then press the [Confirmation] key.
The <Parametric coef.> edit screen is displayed.
3
Use [] or [] to move the cursor to the item to set
and press the [Confirmation] key to change the
item.
• Pressing the [Confirmation] key causes the cursor to
appear on the value. Press [] or [] to change the
value. Move the cursor between the digits of the value by
pressing [] or [].
Settings
0.01 to 30.00
{ „
• Press the [Confirmation] key to confirm every time the
setting of an item is changed.
4
After all settings have been configured, use [] or
[] to move the cursor to "OK", and then press the
[Confirmation] key.
The setting is confirmed and the screen returns to the
<Parametric coef.> screen.
If [ESC] is pressed during setup, the settings will not be
Notes
changed and the screen will return to the <Parametric
coef.> screen.
5
Press [ESC] to return to the <Default data setup>
screen.
83
Sample
0002 TARGET-2
Parametric coef.
Setting
25°
Default data setup
1.00
l (CMC):
Default tolerance
1.00
c (CMC):
Warning level
80%
Parametric coef.
OK Cancel
Sample
0002 TARGET-2
Parametric coef.
Setting
25°
Default data setup
1.00
l (CMC):
Default tolerance
1.50
c (CMC):
Warning level
80%
Parametric coef.
OK Cancel