Mitsubishi Electric MELSEC iQ-R Series User Manual page 328

Number of slave modules with inter-module peak current suppression function enabled
The number of slave modules to which the inter-module peak current suppression function has been enabled can be checked.
Check it with the temperature control module where 'Inter-module peak current suppression function master/slave selection
monitor' (Un\G2102) has been set to Master (1).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area name
Number of slave modules with inter-module peak current suppression function
enabled
Number of slave modules with inter-module peak current suppression function
enabled (in the Q compatible mode)
Start I/O of slave module with inter-module peak current suppression function enabled
The start I/O number of the slave modules to which the inter-module peak current suppression function has been enabled can
be checked.
Check it with the temperature control module where 'Inter-module peak current suppression function master/slave selection
monitor' (Un\G2102) has been set to Master (1).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area name
Start I/O of slave module with inter-module peak current suppression function
enabled
Start I/O of slave module with inter-module peak current suppression function
enabled (in the Q compatible mode)
Inter-module simultaneous temperature rise function state monitor
The status of the inter-module simultaneous temperature rise function can be checked.
The status of the inter-module simultaneous temperature rise function of the channel corresponding to each bit is stored.
• 0: Stop
• 1: In execution
b15
0 0 0 0 0
Bit data from b15 to b4 are fixed to 0.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area name
Inter-module simultaneous temperature rise function state monitor
Inter-module simultaneous temperature rise function state monitor (in the Q
compatible mode)
APPX
326
Appendix 3 Buffer Memory Areas
to b4
0 0 0 0 0 0 0
CH1
2103
1283
CH1
2104 to 2166
1284 to 1346
b3 b2 b1 b0
CH4 CH3 CH2 CH1
CH1
2170
1350
CH2 CH3
CH2 CH3
CH2 CH3
CH4
CH4
CH4