Mitsubishi Electric MELSEC iQ-R Series User Manual page 325

■Occurrence of a write data error
When a value out of the setting value is set, an out of setting range error (error code: 1950H) occurs. 'Error flag' (X2) turns ON
and the error code is stored in 'Latest error code' (in the Q compatible mode) (Un\G0).
■Default value
The default value is CTL-12-S36-8 (0.0 to 100.0A) (0).
When CT ratio setting (0.0 to 100.0A) (2) has been selected, the setting of 'CT1 CT ratio setting' (in the Q
compatible mode) (Un\G288) is enabled. In advance, set a value in 'CT1 CT ratio setting' (in the Q compatible
mode) (Un\G288) corresponding to the sensor to be connected. After that, select CT ratio setting (0.0 to
100.0A) (2).
APPX
Appendix 3 Buffer Memory Areas
A
323