Mitsubishi Electric MELSEC iQ-R Series User Manual page 280

CH1 Cooling control output cycle setting
Set the pulse cycle (ON/OFF cycle) of the transistor output.
The ON time of the control output cycle is determined by multiplying the control output cycle by the manipulated value for
cooling (MVc) (%) calculated by a PID operation. When the manipulated value for cooling (MVc) is stable, pulses are
repeatedly output in the same cycle. For details on this area, refer to the following:
Page 261 CH1 Control output cycle setting
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area name
CH Cooling control output cycle setting
CH Cooling control output cycle setting (in the Q compatible mode)
CH1 Cooling method setting
Set a cooling control method in the heating-cooling control. Select a cooling method suitable for cooling characteristics of
devices.
For details on the cooling method setting function, refer to the following:
Page 34 Cooling Method Setting Function
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area name
CH Cooling method setting
■Setting range
• 0H: Air cooling
• 1H: Water cooling
• 2H: Linear
■Enabling the settings
Turn ON and OFF 'Setting change command' (YB) in the setting mode ('Setting/operation mode status' (X1): OFF) to enable
the settings.
■Default value
The default value is Air cooling (0H).
APPX
278
Appendix 3 Buffer Memory Areas
CH1 CH2
522 722
722 738
CH1 CH2
523 723
CH3 CH4
922 1122
754 770
CH3 CH4
923 1123