Mitsubishi Electric MELSEC iQ-R Series User Manual page 224

Interrupt factor generation setting [n]
Configure the interrupt request setting for when an interrupt factor occurs while the same interrupt factor has been detected.
Setting value
0
1
• When 'Interrupt factor generation setting [n]' (Un\G200 to Un\G215) is Interrupt reissue request (0) and an interrupt factor
occurs while the same interrupt factor has been detected, an interrupt request is sent to the CPU module again.
• When 'Interrupt factor generation setting [n]' (Un\G200 to Un\G215) is No interrupt reissue request (1) and an interrupt
factor occurs while the same interrupt factor has been detected, no interrupt request is sent to the CPU module.
• To send an interrupt request to the CPU module, set 'Interrupt factor reset request [n]' (Un\G156 to Un\G171) to Reset
request (1) and 'Interrupt factor detection flag [n]' (Un\G5 to Un\G20) to No interrupt factor (0).
When a value other than the above has been set, an interrupt factor generation setting error (error code: 180H) occurs.
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area
name
Interrupt factor generation
setting [n]
Interrupt factor generation
setting [n] (in the Q
compatible mode)
■Enabling the settings
Turn ON and OFF 'Setting change command' (YB) in the setting mode ('Setting/operation mode status' (X1): OFF) to enable
the settings.
■Default value
The default value is Interrupt reissue request (0).
Condition target setting [n]
Set the factor to detect interrupts.
Setting value
0
1
2
3
4
5
6
7
8
9
10
11
12
*1 The R60TCTRT2TT2BW and R60TCRT4BW only
When a value other than the above has been set, a condition target setting range error (error code: 181H) occurs.
When an input signal (X) or buffer memory area set in 'Condition target setting [n]' (Un\G232 to Un\G247) turns from OFF to
ON, an interrupt request is sent to the CPU module.
"n" indicates an interrupt setting number. (n = 1 to 16)
APPX
222
Appendix 3 Buffer Memory Areas
Setting details
Interrupt reissue request
No interrupt reissue request
1 2 3 4 5
200 201 202 203 204
3096 3097 3098 3099 3100
Setting details
Disable
Error flag
Hardware error flag
Temperature rise completion flag
Temperature conversion completion flag
Alert definition (Input error)
Alert definition (Rate alarm)
Alert definition (Alert 1)
Alert definition (Alert 2)
Alert definition (Alert 3)
Alert definition (Alert 4)
Alert definition (Heater disconnection) (including output off-time current errors)
Alert definition (Loop disconnection)
6 7 8 9 10
205 206 207 208 209
3101 3102 3103 3104 3105
11 12 13 14 15
210 211 212 213 214
3106 3107 3108 3109 3110
*1
16
215
3111