Mitsubishi Electric MELSEC iQ-R Series User Manual page 225

■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area 1
name
Condition target setting [n] 232
Condition target setting [n] (in 3128
the Q compatible mode)
■Enabling the settings
Turn ON and OFF 'Setting change command' (YB) in the setting mode ('Setting/operation mode status' (X1): OFF) to enable
the settings.
■Default value
The default value is Disable (0).
Condition target channel setting [n]
Set the channels to detect interrupts.
Setting value
0
1
2
3
4
When a channel has been specified in 'Condition target setting [n]' (Un\G232 to Un\G247), interrupt factors in the channel set
in this area are monitored. When an input signal (X) has been set, the settings in this area are ignored.
When a value other than the above has been set, a condition target channel setting range error (error code: 182H) occurs.
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area 1
name
Condition target channel 264
setting [n]
Condition target channel 3160
setting [n] (in the Q
compatible mode)
■Enabling the settings
Turn ON and OFF 'Setting change command' (YB) in the setting mode ('Setting/operation mode status' (X1): OFF) to enable
the settings.
■Default value
The default value is All channels (0).
2 3 4 5 6
233 234 235 236 237
3129 3130 3131 3132 3133
Setting details
All channels
CH1
CH2
CH3
CH4
2 3 4 5 6
265 266 267 268 269
3161 3162 3163 3164 3165
7 8 9 10 11
238 239 240 241 242
3134 3135 3136 3137 3138
7 8 9 10 11
270 271 272 273 274
3166 3167 3168 3169 3170
Appendix 3 Buffer Memory Areas
12 13 14 15 16
243 244 245 246 247
3139 3140 3141 3142 3143
12 13 14 15 16
275 276 277 278 279
3171 3172 3173 3174 3175
APPX
223
A