Test Results - Avaya Hirschmann MACH1040 Technical Configuration Manual

5.2 Test results

The following table shows the test results:
Test Cases
Autonegotiation ERS5600  Hirschmann™
(copper)
No Autonegotiation ERS5600  Hirschmann™
(copper)
Ping PC1 PC2 (both directions, copper)
Fail Link 1 (remove cable from port)
Recover Link 1 (plug cable back into port)
ERS5600  Hirschmann™ (fiber)
Ping PC1 PC2 (both directions, fiber)
Fail Link 1 (remove fiber from port)
Recover Link 1 (plug fiber back into port)
Multicast Test Cases for MACH1040 only
Multicast stream from PC1 to PC2, IGMPv1
Multicast stream from PC1 to PC2, IGMPv2
Multicast stream from PC1 to PC2, IGMPv3
Table 1 ERS 5600 Switch single connection to Hirschmann™ switches
Notes
1. Hirschmann™ switch ports with Spanning Tree (STP) enabled may take upwards of 30 seconds to become active.
Hirschmann™ switches do not support Fast-mode STP. For all test cases, unless stated, STP will be disabled on
ports.
2. On Hirschmann™ switches, when Auto Configuration (Autonegotiation) is disabled, 'Manual Cable Crossing' must
be set for link to come up and 1000MB Full/Half Duplex cannot be configured.
3. For Multicast test cases, Active Querier is enabled on Hirschmann™ MACH switch and IGMP Snooping enabled
on Avaya switch.
4. IGMPv3 Snooping is not currently supported on Avaya switch. For test case, IGMP Snooping is disabled on the
ERS 5600.
June 2011
MACH1040
1
Pass
2
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Avaya Inc. – External Distribution
ERS 5000 Series with Hirschmann™ IE Switches TCG
avaya.com
Test Results
RS30 MS30
1
Pass Pass
2
Pass Pass
Pass Pass
Pass Pass
Pass Pass
Pass Pass
Pass Pass
Pass Pass
Pass Pass
Test Results
3
Pass
3
Pass
4
Pass
1
2
14