Oracle ZFS ZS3 Series Customer Service Manual page 289

6. Repeat steps 3 and 4 on Controller B.
How to Prepare to Update Clustered Controllers
(CLI)
For information about logging in to and using the CLI, see
in Oracle ZFS Storage Appliance Administration Guide, Release
procedure to prepare to update clustered controllers using the CLI.
Note - For the purpose of this procedure, the first controller to be updated is referred to as
Controller A, the other one is Controller B.
1. Lock the management interface on Controller A, as shown in the following
example:
controller-a:> configuration cluster resources select net/igb0
configuration cluster resources (uncommitted)> set owner=<other controller>
configuration cluster resources (uncommitted)> set type=private
configuration cluster resources (uncommitted)> commit
Note that each controller must be the current owner of the management interface.
2. Lock the management interface on Controller B, as above.
3. Verify each controller has a dedicated management interface and a private
cluster resource.
For each controller, go to the configuration cluster resources context and use the show
command. The following example shows the cluster in Active/Active mode:
controller-a:> configuration cluster resources show
Resources:
RESOURCE
net/igb0
controller-a:> configuration cluster resources show
Resources:
RESOURCE
net/igb1
OWNER TYPE
brm7320-250 private
OWNER TYPE
brm7320-260 private
How to Prepare to Update Clustered Controllers (CLI)
"Command Line Interface (CLI)"
2013.1.5.0. Use the following
LABEL CHANGES DETAILS
Untitled I... no
LABEL CHANGES DETAILS
Untitled I... no
Maintaining the System
10.80.2xx.112
10.80.2xx.114
289