Cartesian Ptp Travel - Siemens SINUMERIK 840D sl Function Manual

Kinematic Transformation (M1)

7.6 Cartesian PTP travel

7.6 Cartesian PTP travel
Function
This function can be used to approach a Cartesian position with a synchronized axis
movement.
It is particularly useful in cases where, for example, the position of the joint is changed,
causing the axis to move through a singularity.
When an axis passes through a singularity, the feed velocity would normally be reduced or
the axis itself overloaded.
Note
The "handling transformation package" is required to implement cartesian PTP travel.
MD24100 $MC_TRAFO_TYPE_1 must be set to the transformation type described in TE4.
The function can only be used meaningfully in conjunction with an active transformation.
Furthermore, the "Cartesian PTP travel" function may only be used in conjunction with the
G0 and G1 commands. Alarm 14144 "PTP travel not possible" is otherwise output.
With active PTP transformation axes
traversed for instance via POS, cannot simultaneously be positioning axes. Alarm 17610 is
activated to prevent this error.
Activating
The function is activated when the PTP command is programmed.
The function can be deactivated again with the CP command. Both these commands are
contained in G group 49.
● PTP command: The programmed Cartesian position is approached with a synchronized
● CP command: The programmed Cartesian point is approached with a path movement
● PTPGO command: The programmed Cartesian PTP motion is performed automatically
Power On
After Power on traversing mode CP is automatically set for axis traversal with
transformation. MD20152 $MC_GCODE_RESET_VALUES[48] can be used to switch the
default setting to cartesian PTP travel.
544
axis motion (PTP=point-to-point)
(default setting), (CP=continuous path)
with each G0 block. The CP command is then set again.
Function Manual, 01/2008, 6FC5397-1BP10-3BA0
Extended Functions