Write Online Tool Offset Discretely; Information About Online Offsets - Siemens SINUMERIK 840D sl Function Manual

18.3.5

Write online tool offset discretely

PUTFTOC
This command writes an offset value by means of a program command.
PUTFTOC(<value>, <length1_2_3>, <channel no.>, <spindle no.>)
Put Fine Tool Offset Compensation
The wear of the specified length (1, 2 or 3) is modified online by the programmed value.
Note
The online tool offset for a (geometric) grinding tool that is not active can be activated by
specifying the appropriate spindle number.
If the channel number is omitted, the online offset is effective in the same channel.
If the spindle number is omitted, the online offset is applied to the current tool.
18.3.6

Information about online offsets

Response in the case of tool change
● In cases where FTOCON has been active since the last tool or cutting edge change,
● Cutting edge changes can be implemented without preprocessing stop.
Machining plane and transformation
● FTOCON can be used only in conjunction with the "Inclined axis" transformation.
● It is not possible to change transformations or planes (e.g. G17 to G18) when FTOCON is
Extended Functions
Function Manual, 01/2008, 6FC5397-1BP10-3BA0
preprocessing stop with resynchronization is initiated in the control when a tool is
changed.
Note
Tool changes can be executed in conjunction with the online tool offset through the
selection of T numbers.
Tool changes with M6 cannot be executed in conjunction with the online tool offset
function.
active, except in the FTOCOF state.
Grinding-specific tool offset and tool monitoring (W4)
18.3 Online tool offset
985