Siemens SINUMERIK 840D sl Function Manual page 853

● Application example:
Example:
Programming
POS[C] = AC (-100)
POS[C] = AC (1500)
Absolute programming along the shortest path (DC)
POS[axis name] = DC(value)
Even if the rotary axis is not defined as a modulo axis, the axis can still be positioned with DC
(Direct Control). The response is the same as on a modulo axis.
● The value identifies the rotary-axis target position in a range from 0° to 359.999° (modulo
● With DC (Direct Control), the rotary axis approaches the programmed absolute position
● The control calculates the direction of rotation and the traverse path according to the
● DC application example: the rotary table is required to approach the changeover position
● If DC is programmed with a linear axis, alarm 16800, "DC traverse instruction cannot be
Example:
Programming
POS[C] = AC (7200)
POS[C] = DC(300)
POS[C] = AC (7000)
Extended Functions
Function Manual, 01/2008, 6FC5397-1BP10-3BA0
Linear movements (cam gear) are linked to the rotary axis, thus certain end positions
may not be overtraveled.
360°). Alarm 16830, "Incorrect modulo position programmed", is output for values with a
negative sign or ≥ 360º.
within one revolution along the shortest path (traversing movement max. ± 180°).
current actual position (in relation to modulo 360°). If the path to be traversed is the same
in both directions (180°), the positive direction of rotation receives preference.
in the shortest time (and, therefore, via the shortest path) possible.
used", is output.
Effect
Rotary axis C traverses to position -100°;
traversing direction depends on the starting position
Rotary axis C traverses to position 1500°
Effect
Rotary axis C traverses to position 7200°;
traversing direction depends on the starting position
Rotary axis C approaches "modulo" position 300°
along the shortest path
Thus, C traverses about 60° with a negative direction of rotation
and stops at absolute position 7140°.
Rotary axis C traverses to position 7000° absolutely,
so C traverses about 140° with a negative direction of rotation
Rotary Axes (R2)
13.3 Programming rotary axes
853