Persistent Transformation - Siemens SINUMERIK 840D sl Function Manual

Kinematic Transformation (M1)
7.5 Chained transformations
7.5.4

Persistent transformation

Function
A persistent transformation is always active and has a relative effect to the other explicitly
selected transformations. Other selected transformation are computed as the first chained
transformation in relation to the persistent transformation.
Transformations such as TRANSMIT that must be selected in relation to the persistent
transformation must be parameterized in a chain with the persistent transformation by means
of TRACON. It is the first chained transformation rather than the TRACON transformation
which is programmed in the parts program.
For additional programming tips see
References:
/PGA/ Programming Manual, Work Preparation; Transformations "Chained Transformation"
Selection and deselection
Persistent transformation is selected via the following machine data:
MD20144 $MC_TRAFO_MODE_MASK, Bit 0 = 1
MD20144 $MC_TRAFO_RESET_VALUE defines persistent transformation.
MD20140 $MC_TRAFO_RESET_VALUE=Number of the transformation data set of the
persistent transformation
In addition the following must be set (i.e. noted):
MD20110 $MC_RESET_MODE_MASK
Bit 0 = 1 (Bit 7 is evaluated)
Bit 7 =0 (MD20140 $MC_TRAFO_RESET_VALUE determines the transformation data set)
MD20112 $MC_START_MODE_MASK (MD20140 $MC_TRAFO_RESET_VALUE)
MD20118 $MC_GEOAX_CHANGE_RESET= TRUE (i.e. geometry axes are reset).
If this additional data is not parameterized correctly,
alarm 14404 is generated.
With TRAFOOF the active TRACON is deselected and the persistent transformation is
automatically selected.
Effects on HMI operation
As a transformation is always active with the persistent transformation, the HMI user
interface is adapted accordingly for the selection and deselection of transformations:
TRACON on HMI
Accordingly the HMI operator interface does not display TRACON, but the first chain
transformation of TRACON e.g. TRANSMIT . Accordingly, the transformation type of the 1st
chained transformation is returned by the corresponding system variable, i.e. $P_TRAFO
and $AC_TRAFO. Cycles written in TRANSMIT can then be used directly.
536
Function Manual, 01/2008, 6FC5397-1BP10-3BA0
Extended Functions