Siemens SINUMERIK 840D sl Function Manual page 882

Extended functions
Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

Synchronous Spindles (S3)
14.2 Programming of synchronous spindle couplings
Programmable block change
It is possible to mark a point in the NC program using the "WAITC" language instruction. The
system waits at this point for fulfillment of the synchronism conditions for the specified FS
and delays changes to new blocks until the specified state of synchronism is reached (see
Figure).
WAITC (FS)
Advantage: The time between activating the synchronous coupling and reaching
synchronism can be used in a meaningful way, technologically speaking.
Note
Basically, it is always possible to write WAITC. If the spindle indicated is not active as FS,
the instruction for this spindle is without effect.
If no synchronism condition is indicated, the check is always performed for the synchronism
condition programmed/configured on the respective coupling, at least for the setpoint
synchronism.
Examples:
WAITC(S2),
:
WAITC(S2, "Fine"),
:
WAITC(S2, ,S4, "Fine")
Stop and block change
If "Stop" has been activated for the cancellation period of the axis enables for the leading or
following spindle, then the last setpoint positions with the setting of the axis enables from
the servo drive are approached again.
Program instructions COUPON and WAITC can influence the block change behavior. The
block change criterion is defined using COUPDEF or via the MD21320
$MC_COUPLE_BLOCK_CHANGE_CTRL_1.
882
Function Manual, 01/2008, 6FC5397-1BP10-3BA0
Extended Functions

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 840de sl

Table of Contents