Several Operator Panel Fronts And Ncus, Standard Functionality; Configurations - Siemens SINUMERIK 840D sl Function Manual

2.3

Several operator panel fronts and NCUs, standard functionality

The M:N concept without the Control Unit Management option is described below.
Note
This section does not apply to the HT6, since only one HT6 can be operated on an NCU
without control unit management.
2.3.1

Configurations

Configuration parameters
As it is possible to freely combine hardware components, it is necessary to inform the
system which components are combined and in what manner. On the HMI Advanced, this is
done by means of an operator dialog in the commissioning area. In the case of the HMI
Embedded/OP030, the configuration parameters are entered through the creation of a
configuration file which is loaded for commissioning. The file must be structured as described
below.
Figure 2-14
Extended Functions
Function Manual, 01/2008, 6FC5397-1BP10-3BA0
Several Operator Panels on Several NCUs, Distributed Systems (B3)
2.3 Several operator panel fronts and NCUs, standard functionality
Structure of configuration file NETNAMES.INI
125