Tool-Specific Grinding Data - Siemens SINUMERIK 840D sl Function Manual

18.2.3

Tool-specific grinding data

Tool-specific grinding data
Tool-specific grinding data are available once for every T number (type 400 - 499). They are
automatically set up with every new grinding tool (type 400 - 499).
Note
Tool-specific grinding data have the same characteristics as a tool edge.
This is to be taken into account when the number of cuts is specified:
MD18100 $MN_MM_NUM_CUTTING_EDGES_IN_TOA
When all the cutting edges of a tool are deleted, the existing tool-specific grinding data are
deleted at the same time.
Parameters
The parameters are assigned as follows:
Parameter
$TC_TPG1
$TC_TPG2
$TC_TPG3
$TC_TPG4
$TC_TPG5
$TC_TPG6
$TC_TPG7
$TC_TPG8
$TC_TPG9
Additional parameters (user-specific cutting edge data)
$TC_TPC1
to
$TC_TPC10
Definition of additional parameters $TC_DPC1...10
For the user-specific cutting data the additional parameters $TC_DPC1 to $TC_DPC10 can
be implemented independent of the WZ-type. This is done via the general machine data:
MD18096 $MN_MM_NUM_CC_TDA_PARAM
Changes to the MD take effect after POWER ON and will lead to initialization of the
memory (back data up beforehand if necessary!).
Extended Functions
Function Manual, 01/2008, 6FC5397-1BP10-3BA0
Meaning
Spindle number
Chaining rule
Minimum wheel radius
Minimum wheel width
Current wheel width
Maximum speed
Maximum peripheral speed
Angle of inclined wheel
Parameter number for radius calculation
CAUTION
Grinding-specific tool offset and tool monitoring (W4)
18.2 Tool offset for grinding operations
Data type
Integer
Integer
Real
Real
Real
Real
Real
Real
Integer
Real
969