Graphical Data; Network - Barco TransForm SCN User Manual

3.2.2 Graphical data

The T F SCN is capable to decode the analog or digital graphical output of a computer.
RANS ORM
Formats
An analog or digital VESA source up to 1600×1200@60 Hz (UXGA) with up to 24 bpp color depth can be encoded,
please refer also to section
Connection
The T F SCN comes with a set of cables and adapters for graphical data:
RANS ORM
•
cable DVI-I –> DVI-I
•
cable VGA 15 pin -> DVI-A
•
adapter DVI-A -> VGA 15 pin
They can be used depending on the type of the graphic connectors of the graphic card of the host PC and of the
monitor.
For the connection of the host PC with the DVI in [9] connector of the T
DVI-I or VGA – DVI-A can be used, depending on the connector type of the host PC.
If you want to loop through the signal and display it on a monitor or other displaying device, connect the DVI out
[10] connector with the displaying device. For that purpose you can use the so far used cable. If this cable has a
VGA plug you can use the DVI-A -> VGA 15 pin adapter to connect it to the T
To be able to use DDC information of the monitor, it must be connected before the
TransForm SCN is connected to the power supply.

3.2.3 Network

For the network connection the network adapter on the back of the T
connector suitable for a 10/100 Mbps connection.
Connection
Plug the network cable into the LAN adapter [14] on the rear of T
Network requirements
property
speed
port
bandwidth
Barco – TransForm SCN – R5976968 – Revision 01 – May 2006
7.1 Technical data.
9
requirement
100 Mbps full duplex
switched (no hub)
capacity to transport a 30 Mbps T
________________________________________________________________________________________________
F SCN the provided cables DVI-I –
RANS ORM
F SCN.
RANS ORM
10
F SCN is used. It consists of an RJ45
RANS ORM
F SCN.
RANS ORM
F SCN stream without packet loss
RANS ORM
3. Getting started
Figure 3-4
connecting a graphical data source
Table 3-1
3-5