Table of Contents
Advertisement
Source
This selects a modulation source to control the Speed. For a
list of Dmod sources, see the "Dynamic Modulation Source
List" on page 910.
Amount
This controls the depth and direction of the Speed
modulation.
192: Vintage Flanger
A model of a truly classic analogue flanger. This amazing
stompbox's bucket-brigade technology provides a sweeping,
whooshing sound, perfect for chords.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
+
Right
LFO
LFO Sync
LFO
Speed [Hz]
This controls the speed of the LFO.
Source
This selects a modulation source to control the Speed. For a
list of Dmod sources, see the "Dynamic Modulation Source
List" on page 910.
Amount
This controls the depth and direction of the Speed
modulation.
LFO Reset Source
This selects a modulation source to reset the LFO. You can
use this to re-start the flanger's jet-like, rolling motion just
before a big power chord, for instance. This will be most
useful when the Speed is set relatively low.
Reset Offset Amount
This controls the phase of the LFO when reset.
193: Red Comp
Need to play clean chordal passages with smooth, even
dynamics? Then, look no further: this compressor is
modeled on a pedal whose clean sound made it hugely
popular. Perfect for pop and funk music.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
+
Envelope - Control
Right
894
[List of Dmod Sources]
[–10.0...+10.0]
Wet / Dry
Resonance
Flanger
Wet / Dry
Reset Offset
[0.10...10.00]
[List of Dmod Sources]
[–10.0...+10.0]
[List of Dmod Sources]
[0...100]
Wet / Dry
Compressor
Level
Wet / Dry
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.
FLANGER
Depth
Sets the depth of LFO modulation.
Source
This selects a modulation source to control the Depth.
Amount
This controls the depth and direction of the Depth
modulation.
Resonance
This controls the intensity of the flanger effect, via feedback.
Manual
This adjusts the offset of the LFO sweep, effectively
increasing the center delay time of the chorus.
When Depth is set to the maximum of 100, this has no
effect.
Source
This selects a modulation source to control the Manual
amount.
Amount
This controls the depth and direction of the Manual
modulation.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.
COMPRESSOR
Sensitivity
This controls the amount of compression. Increasing the
value boosts lower level sounds, and raises the overall
volume.
To adjust the final volume, use the Output Level parameter.
Attack
This controls the onset time of the compressor.
[0...100]
[List of Dmod Sources]
[–100...+100]
[0...100]
[1...100]
[List of Dmod Sources]
[–100...+100]
[1...100]
[1...100]
Advertisement
Table of Contents
