Sampling > Loop Edit; 2-1: Loop Edit - Korg NAUTILUS Series Parameter Manual

SAMPLING > Loop Edit
In this page you can specify the region of the sample that
will play and the portion that will loop. You can edit the
waveform down to the level of individual samples while
watching the sample waveform display. Here are the main
operations you will perform in this page.
• Specify the looping locations (start address, loop start
address, end address)
• Truncate (delete unwanted regions), copy, paste, move
2–1: Loop Edit
2–1a
2–1b
2–1c
2–1d
2–1a: Multisample Select (MS)
Multisample Select
Here you can select the multisample to edit.
Keyboard
For more information, please see "0–1a: Multisample Select
(MS)" on page 574.
2–1b: Index, Sample Select, Range
Index [xxx (001...127)/yyy (001...127)]
Selects the index whose loop and other sample parameters
you wish to edit. Your edits will apply to the sample of the
index selected here, and the waveform will appear in the
Sample waveform display (0–1a).
You can also select an index by holding down the ENTER
button and playing a note on the keyboard. The index that
includes this note will be selected. The note you played will
be the base key, and will be shown in green in the keyboard
graphic. ("Keyboard" 0–1a)
• When performing the above operations, you can
automatically detect zero-crossing points, or display a
grid (vertical lines) and edit according to BPM values or
beats
• Make settings for reverse (backward) playback
• Use the Time Slice or Time Stretch functions to
automatically edit the sample according to BPM values
or beats
Sample Select
[0000...3999]
Range
This selects the sample of the index. If you change "Sample
Select," the sample you specify will be assigned to this index
(0–1b). The sample you select here will appear in the
"Sample waveform display."
The range of the index is displayed at the right.
2–1c: Sample waveform display
Sample waveform display
This shows the waveform of the selected Sample. For more
information, please see "1–1c: Sample waveform display"
on page 586.
2–1d: Sample Setup
Start (Start Address)
This specifies the start point for sample playback, in single-
sample units.
SAMPLING > Loop Edit 2–1: Loop Edit
2–1PMC
2–1e 2–1f
[----: ---No Assign----,
00000...15999]
[C–1...G9 – C–1...G9]
[000000000...]
589