Table of Contents
Advertisement
MEDIA mode
.KSC Allocation
.KMP file to load
KMP000
KMP001
KMP003
Append
KMP005
KMP000
KMP001
KMP003
Clear
KMP005
5. Set the Load Method as desired.
This sets the preferred way to load the EXs and User
Sample Bank data in the KSC: load it into RAM, or use
Virtual Memory. Note that if the data is extremely large,
and would not fit into RAM regardless of which other
samples were loaded, the data will use Virtual Memory
regardless of this setting.
These settings apply only to EXs and User Sample
Banks; SAMPLING mode data is always loaded into
RAM.
RAM: The samples will be loaded into RAM. This has
the advantage of allowing reverse playback.
Virtual Memory: The samples will use Virtual Memory.
This generally allows you to load more large samples at
once. Note that the samples may still require a significant
amount of RAM.
KSC Settings: KSCs can store separate load method
settings for each Multisample or Drum Sample, based on
the settings when the KSC was saved. Setting Load
method to KSC Settings uses these individual settings.
6. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
704
Internal memory of the
Internal memory of the
KRONOS after loading
KRONOS before loading
KMP000
KMP000
KMP002
KMP002
KMP003
KMP003
KMP004
KMP005
KMP006
KMP007
KMP000
KMP000
KMP001
KMP002
KMP003
KMP003
KMP005
Load Programs
All program data from the .PCG file will be loaded.
1. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
Load Program Bank
All program data of the selected bank will be loaded into the
bank you specify.
1. In "To," select the loading destination bank.
2. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
Note: Data cannot be loaded into INT–G.
You can load banks of a different type (HD-1 or EXi) from
the NAUTILUS's current bank type setting; the bank type
will be changed automatically as required.
If "Multiple Select" (0–1a) is checked and you've selected
more than one bank, the data will be loaded starting with the
bank specified in the "To" field.
Load a single Program
Data for the selected program will be loaded into the
program number you specify.
1. If you wish to load a program other than the one
already selected, use "Program" (upper line) to select
the program that you wish to load.
Note: Whenever you've selected an individual Program,
Combination, Drum Kit, or Wave Sequence from within a
PCG file, you can play it from the keyboard
immediately–no need to load it into memory! For more
information, see "Auditioning sounds from disk" on
page 695.
2. In "To Program," (lower line) select the bank and
program into which the data will be loaded. When you
press the popup button, the "Bank/Program Select"
window (PROGRAM 0–1a) will appear.
[A...T]
Advertisement
Table of Contents
