087: Reverse Delay - Korg NAUTILUS Series Parameter Manual

BAND4 LFO
Band 4's LFO has the same parameters as the "BAND1
LFO," above.

087: Reverse Delay

This is a delay that plays back the input signal in reverse.
You can also continue feedback while alternating playing the
signal in reverse and forward directions.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
Feedback
Feedback
+
Reverse
Trim Sync High Damp
Right
D -mod
Trigger
INPUT
Input Level Dmod [%]
Sets the modulation amount of the input level.
Source
Selects the modulation source for the input level.
REVERSE DELAY
Reverse Time [msec]
Sets the length of the reverse playback (the delay time). For
more information, see "Reverse Time and Sync Source,"
below.
Level
Sets the output level of the reverse playback.
L Post-Delay Time [msec]
Sets the delay time of the Left Tap.
Level
Sets the output level of the Left Tap.
R Post-Delay Time [msec]
Sets the delay time of the Right Tap.
Level
Sets the output level of the Right Tap.
Feedback Mode [Reverse, Reverse/Forward]
Reverse: the feedback plays in reverse.
Reverse/Forward: the feedback alternates between playing
backwards and forwards, as shown below.
Wet / Dry
Feedback Mode
Delay
Level
Wet / Dry
[+/–100]
[Off...Tempo]
[0...900]
[0...100]
[0...900]
[0...100]
[0...900]
[0...100]
Delay 087: Reverse Delay
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.
Input
Feedback Mode: Revese
wet
Feedback Mode: Revese/Forward
wet
Feedback
Sets the feedback amount.
Source
Selects the modulation source of feedback amount.
Amount
Sets the feedback amount.
High Damp [%]
Sets the amount of high-frequency attenuation for the
feedback path.
Sync Source
Selects a modulation source to reset the start point of the
reverse delay. For more information, see "Reverse Time and
Sync Source," below.
Reverse Time and Sync Source
The sound will be played in reverse for the duration
specified by Reverse Time. You can reset the dividing point
for reverse playback by specifying a modulation source for
Sync Source.
Reverse Time
Input
wet
Reverse Time
If you set Sync Source to Gate1, the delay will be reset at
each note-on. This means that you will always hear the
reverse playback of the sound that occurs between the note-
on and the specified Reverse Time.
If you don't specify a Sync Source, the location at which
reverse playback starts will be indeterminate.
Feedback Mode
Time
[+/–100]
[Off...Tempo]
[+/–100]
[0...100]
[Off...Tempo]
Reverse Time/Sync
Sync
reset
Time
841