Ms-20Ex: Tone Adjust - Korg NAUTILUS Series Parameter Manual

MS-20EX: Tone Adjust

MS-20EX Tone Adjust Default Settings
VCO1 VCO2
Waveform Waveform
EG1 EG1
Delay Attack
Tone Adjust provides an elegant physical interface to the
MS-20EX's parameters. Most of the factory sounds use the
default layout, as shown above. You can also customize the
layout for individual sounds, if desired.
For more information about Tone Adjust, please see "0–9a:
Tone Adjust," on page 29.
Common Tone Adjust parameters
These parameters affect both EXi 1 and 2. Except as noted
below, the Common Tone Adjust parameters behave as
described under "Common Tone Adjust Parameters," on
page 31.
MS-20EX: Tone Adjust Common Tone Adjust parameters
HPF HPF HPF
Cutoff Peak EG2/Ext Mod
EG1 EG2 EG2
Release Attack Decay
LPF LPF LPF
Frequency Peak EG2/Ext Mod
EG2 EG2 MG
Sustain Release Waveform
Filter Cutoff. (–99...+99, CC#74)
This scales the cutoff frequency of the lowpass filter. To
adjust the highpass filter, use the separate, MS-20EX-
specific Tone Adjust parameters.
Filter Resonance. (–99...+99, CC#71)
This scales the resonance (PEAK) of the lowpass filter. To
adjust the highpass filter, use the separate, MS-20EX-
specific Tone Adjust parameters.
Filter EG Intensity. (–99...+99, CC#79)
This scales the EG2/EXT knob for the lowpass filter.
Amp Velocity Intensity. (–99...+99)
Not supported.
Filter/Amp EG Attack Time.
(–99...+99, CC#73)
This scales the attack time of EG2, which is normalled to
both filter cutoff and amplitude.
Button 7, 8, 15, 16:
LFO 1, 2, 3, 4 Stop
MG
Freq/Times
279