Table of Contents
Advertisement
SAMPLING > MFX/TFX
Here you can select the effect types for the master effects
and total effects, and turn them on/off.
The master effects are output to the L/R bus. The total
effects are inserted in the L/R bus. If you want to use these
while sampling, set Source Bus to L/R.
For more information, please see the "Effect Guide,"
beginning on page 729.
9–1: Routing
9–1a
9–1b
9–1a: MFX
The master effect does not output the direct sound (Dry).
Adjust the Return 1 and Return 2 levels to return the signal
to the L/R bus and mix it with the L/R bus signal.
The master effects are stereo-in/out, but depending on the
selected effect type, the output may be monaural. See
"In/Out" on page 737.
The meters below the effects names display the effect output
levels in realtime, showing the combined peak signals of the
left and right channels.
MFX1
MFX1
This selects the effect type for master effect 1. Choose from
000:No Effect – 197: Rotary Speaker Pro CX Custom. If you
choose 000:No Effect, the output from the master effect is
muted.
Category/MFX Select menu
When you press the popup button, the Category/MFX Select
menu will appear, letting you select effects by category. Use
the tabs to select a category, and then select an effect within
that category. Press the OK button to execute your selection,
or press the Cancel button to cancel.
Note: When you sample, MFX1 On/Off, MFX2 On/Off,
TFX1 On/Off, and TFX2 On/Off are automatically turned
off. This is done so that the effect will not be applied again
(i.e., a second time) when you play back the sample that was
resampled with the MFX1/2 and TFX1/2. (In the same way,
the Bus Select (All OSCs to) parameter will automatically
be set to L/R.) Be aware of this if you want to sample again.
MFX1 On/Off
Switches the master effects 1 on/off. When off, the output
will be muted. This will alternate between on and off each
time it is pressed.
Separately from the settings here, you can use control
change #94 to turn master effects 1 and 2 off. A value of 0
turns them off, and values of 1–127 restore the original
setting. The global MIDI channel specified by MIDI
Channel (GLOBAL 1–1a) is used for this message.
Return 1
This specifies the return level from the master effect to the
L/R bus (after which it passes through TFX1 and 2, and is
sent from L/MONO and R).
[000...197]
MFX2
MFX2
MFX2 On/Off
Return 2
These parameters specify the effect type for master effect 2,
its on/off status, and the return level from master effect 2 to
the L/R bus. See "MFX1" on page 601.
SAMPLING > MFX/TFX 9–1: Routing
9–1PMC
[Off, On]
[000...127]
[000...197]
[Off, On]
[000...127]
601
Advertisement
Table of Contents
