Table of Contents
Advertisement
Threshold
Attack [msec]
This determines how quickly the compressor will take affect
after the signal crosses above the threshold.
Release [msec]
This controls how quickly the compressor will stop reducing
volume level after the signal falls below the threshold.
Dry
Wet
Wet
Lookahead
If this is on, the input signal to the compressor is delayed so
that the level will be detected from the trigger input before
the input signal is actually processed. This allows
compression to accurately follow changes in the trigger
input.
Gain Adjust [dB]
Sets the output gain. It's often useful to increase the gain,
since compression causes the entire level to be reduced.
Source
Selects the modulation source for the output gain.
Amount
Sets the amount of output gain modulation.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.
764
Soft Knee Width
Soft Knee Width = 0 dB
Soft Knee Width = 30 dB
Soft Knee Width
Input Level
[0.45...500.0]
[5...5000]
Limiter - Attack / Release
Threshold
Ratio=Inf : 1
Attack=1
Release=1
Ratio=Inf : 1
Attack=100
Release=100
Release
Attack
[Check-box]
[–Inf, –38...+24]
[Off...Tempo]
[–63...+63]
Advertisement
Table of Contents
