Table of Contents
Advertisement
COMBINATION > IFX
You can also specify the bus routing for the program used by
each timbre 1–16. For instance, you can:
• Send the output of a timbre to an insert effect
• Route a sound to an insert effect
8–1: Routing1
8–1a
1–1a
1–1b
8–1b
Specifies the bus to which the program oscillator(s) used by
each timbre 1–16 will be sent. You can also set the send
levels to the master effects from this page.
COMBINATION > IFX 8–1: Routing1
• Make detailed settings for insert effects
• Make common LFO settings for effects
For more details on the Insert Effects, see the "Effect Guide"
on page 729.
8–1a: Routing Map
This shows the status of the insert effects.
This area shows the insert effect routing (Bus Select), the
name of the assigned effect, the on/off status, chaining, and
the output bus that follows the insert effect. The type of
insert effect, the on/off status, and the chain settings can be
edited in the IFX– Insert FX page.
8–1PMC
421
Advertisement
Table of Contents
