Table of Contents
Advertisement
Total Effects (TFX1, 2)
In/Out
The total effects TFX1 and TFX2 are stereo-in and stereo-
out. The Dry (unprocessed) side of the Wet/Dry parameter
sends the stereo input sound directly to the stereo output.
The way in which the Wet (processed) side is output depends
on the type of effect, as follows.
Mono In - Mono Out
Wet
Mono In - Stereo Out
Stereo In - Stereo Out
Mono–Mono Parallel
141: P4EQ//P4EQ-185: Mt.BPM Dly//Mt.BPM Dly
For details, see "Mono–Mono Parallel Effects" on page 737.
Routing
The total effects TFX1 and TFX2 are placed immediately
before the AUDIO OUTPUT (MAIN) L/MONO and R
outputs. Both effects (TFX1 and 2) are available in all
modes.
If the Bus Select setting for an oscillator
(PROGRAM/SAMPLING modes), timbre
(COMBINATION mode), track (SEQUENCER mode), or
audio input (in all modes) or the post-insert Bus Select is set
to L/R, the signal will be output from the AUDIO OUTPUT
(MAIN) L/MONO and R jacks.
The sound from MFX1 and 2 is routed through TFX1 and
TFX2, and then output to AUDIO OUTPUT (MAIN)
L/MONO and R.
If you select 000:No Effect, the stereo input will be passed to
the stereo output without any processing.
You can switch the effects on/off using the MFX1 or 2
ON/OFF buttons or the MFX/TFX– Routing settings in each
mode. When off, the effect will be bypassed. The stereo
input will be passed to the stereo output without any
processing, just as if 000:No Effect is selected.
+
Effect
Separately from this ON/OFF button, MIDI control
change CC#95 can be received to turn TFX1 and TFX2
+
Effect
off. A control change value of 0 turns them off, and a
value of 1–127 restores them to the prior setting. You can
Effect
Effect
also use "Effect Global SW" to turn off TFX1 and TFX2
in the same way. This is controlled on the global MIDI
channel.
Total Effects (TFX1, 2) In/Out
755
Advertisement
Table of Contents
