6-2: Amp Mod - Korg NAUTILUS Series Parameter Manual

v 6–1: Page Menu Commands
• Compare →p.112
• Write Program →p.112
6–2: Amp Mod.
6–2a
6–2b
This page contains the settings for the STR-1's Amp level
modulation. Among other things, you can:
• Set up complex keyboard tracking shapes to control the
Amp level.
• Assign AMS modulation for the Amp level.
• Control the effect of the LFOs on the Amp level.
The total effects of the modulation can increase the volume
to a maximum of two times louder than the Amp Level
setting.
6–2a: Keyboard Track
Keyboard tracking lets you vary the volume as you play up
and down the keyboard. Usually, some amount of key
tracking is necessary in order to make the volume consistent
across the entire range.
The STR-1's Amp keyboard tracking parameters are
identical to the HD-1's. For more detailed explanations of
the parameters, please see "4–2a: Keyboard Track," on
page 76.
There is one difference between the two, however: the STR-
1's Amp tracking is affected by Portamento, so that it
changes smoothly during glides.
Key
Low Break
This sets the breakpoint note between the two lower ramps.
Low-Center
This sets the slope between the Low Break and Center keys.
[C–1...G9]
[-Inf, –99...+99, +Inf]
PROGRAM > STR-1: Amp 6–2: Amp Mod.
• Exclusive Solo →p.113
• PAGE →p.126
• MODE →p.126
Center
This sets the center of the keyboard tracking. At this key, the
keyboard tracking has no effect on the volume, or on any
AMS destinations.
High Break
This sets the breakpoint note between the two higher ramps.
Ramp
Bottom-Low
This sets the slope between the bottom of the MIDI note
range and the Low Break key. For normal key track, use
negative values.
Ramp
-Inf Silent in one half-step
–99 Silent in one whole-step
–95 Silent in one octave
–48 Silent in two octaves
–25 Silent in four octaves
00 no change
+25 x2 in four octaves
+50 x2 in two octaves
+99 x2 in one octave
+Inf x2 in one half-step
For normal key track, use negative values.
6–2PMC
[C–1...G9]
[C–1...G9]
[-Inf, –99...+99, +Inf]
Change in level
243