Table of Contents
Advertisement
PROGRAM mode: HD-1
The Equal Power check-box makes the Vector create a
smooth fade between the two Oscillators, while the OSC1/2
Center Volume parameters allow you to create more
complex fade shapes.
In COMBINATION mode, you can use this to control the
relative volumes of up to 16 Programs at once, using both
the X and Y axes. For more details, see the X-Y Control
section of COMBINATION mode.
Enable Volume Control
When this box is checked, the X-Y position will control the
volumes of Oscillators 1 and 2.
When this box is not checked, the X-Y position will not
directly affect volume. However, it's still possible for the
Vector to control volume via X-Y CCs and AMS.
Note: "X-Y Volume Control" cannot be used to control the
volume of the drum track.
Equal Power
This applies only when Enable Volume Control is turned
On.
When Equal Power is On, the Vector will fade between
Oscillators 1 and 2 using an equal-power volume curve. This
provides a smooth fade between the two sounds, and is the
type of volume control used by classic vector synths.
Also, when this is checked, the OSC 1 and OSC 2 Center
Volume parameters will be grayed out, since Equal Power
sets the center volumes automatically.
When Equal Power is Off, the OSC 1 and OSC 2 Center
Volume parameters determine the way in which X-Y
position affects volume.
OSC1 Center Volume
This sets the volume of Oscillator 1 at the center of the X
axis. It applies only when Equal Power, above, is set to Off.
Vector Synthesis System
X-Y Control
X-Y Control
MIDI In
X-Y Envelope
42
[Off, On]
[Off, On]
[0, 25, 50, 75, 100%]
X-Y CC MIDI Output
Global Controllers
MIDI CC Assignments
Defaults: X=118, Y=119
X-Y CC Control
Scale
X-Y X and Y modes
X-Y Volume Control
Osc 1/2 Center Volume
and Equal Power settings
The volumes at the extreme ends of the X axis are fixed. At
the left side, Osc 1 is always at 100% volume; at the right
side, Osc 1 is always at 0%.
OSC2 Center Volume
This sets the volume of Oscillator 2 at the center of the X
axis.
The volumes at the extreme ends of the X axis are fixed, in
the opposite direction of Oscillator 1's. At the left side, Osc
2 is always at 0% volume; at the right side, Osc 2 is always
at 100%.
Osc Center Volume and X-Axis Position
100%
Volume 50%
0%
-127
X-Y X-axis position
Center Volume Values:
1–5b: X-Y CC Control
X-Y CC Control lets you use the combination of the X-Y
Control and the X-Y Envelope as AMS sources, for
modulating Program parameters, and as DMod sources, for
modulating Effects.
Global switch: MIDI page
X-Y MIDI Out
X-Y Control
X-Y CC Control
X+/– and Y+/–
CC Assignments
Program switch:
Enable CC control
Program switch:
Enable Volume control
[0, 25, 50, 75, 100%]
0
+127
100
75
50
25
0
X-Y CC MIDI Output
X-Y CC Modulation of
Program and FX Parameters
X-Y Modulation of
Oscillator Volume
Advertisement
Table of Contents
