Table of Contents
Advertisement
Level
Wet
Dry
Attack
This controls the onset time of the compressor.
Level
Attack=80
Attack=20
Dry
002: Stereo Compressor
On-screen graphic, 002 Stereo Compressor
The yellow line shows the output level, relative to the input level.
This will change according to the Ratio, Threshold, and Soft Knee Width.
These lights show the relation of the control input to the Threshold and Soft Knee, in real-time.
Under (green) means the input is below the Soft Knee area, and so no compression is occurring.
Knee (yellow) means that the input is within the Soft Knee range. Within this range, as the signal gets
louder, the amount of compression will gradually increase towards the Ratio setting.
Over (red) means that the input is above the Soft Knee range, and the full Ratio is being applied.
This is a sophisticated stereo compressor that allows you to
make detailed settings, such as the level detection method
and the compression curve.
Stereo In - Stereo Out
Left
Side EQ
+
Envelope Select
Envelope Source
Right
FX Control BUS 1
FX Control BUS 2
762
Dyna Compressor - Sensitivity
Sensitivity=100
Sensitivity=40
Time
[1...100]
Dyna Compressor - Attack
Wet
Time
Gain Adjust
Delay
Compressor
Envelope - Control
Side Chain Monitor
Envelope - Control
Delay
Compressor
Gain Adjust
Detection Mode
Lookahead
Output Level
Sets the output level of the compressor.
Source
Selects the modulation source for the Output Level.
Amount
Sets the modulation amount for the Output Level.
OUTPUT
Wet/Dry
Sets the balance between the "wet" processed sound and the
dry input.
Source
Selects a modulation source for Wet/Dry.
Amount
Sets the modulation amount for Wet/Dry.
This meter shows the amount of gain reduction, in
real-time. To show that the gain is being reduced,
the meter moves in the opposite direction from the
Input meter.
The red marks show the Threshold setting.
The light gray area shows the Soft Knee Width.
Notice how the slope of the yellow line changes
as it passes through this range.
The red marks show the Threshold setting.
ENVELOPE
Source
The action of the compressor is controlled by the level of the
selected Source.
Wet / Dry
Input is the normal setting, in which the level of the input
signal controls the compressor.
FX Control 1 or 2 let you process the input signal with the
compressor, while using a completely different signal to
control it. For instance, you might use a different Timbre or
Wet / Dry
Track to duck the input signal. For more information, please
see "FX Control Buses" on page 733.
[Off...Tempo]
[Dry, 1:99...99:1, Wet]
[Off...Tempo]
[Input, FX Control 1, FX Control 2]
[0...100]
[+/–100]
[+/–100]
Advertisement
Table of Contents
