Mod-7: Tone Adjust - Korg NAUTILUS Series Parameter Manual

MOD-7: Tone Adjust

MOD-7 Tone Adjust Default Settings
Buttons 1–6:
VPM Osc 1–6
On/Off
Button 9, 10:
PCM On &
Reverse
Tone Adjust provides an elegant physical interface to the
MOD-7's parameters. Most of the factory sounds use the
default layout, as shown above. You can also customize the
layout for individual sounds, if desired.
For more information about Tone Adjust, please see "0–9a:
Tone Adjust," on page 29.
Common Tone Adjust parameters
Except as noted below, the Common Tone Adjust parameters
behave as described under "Common Tone Adjust
Parameters," on page 31.
Filter/Amp EG Attack Time.
(–99...+99, CC#73)
This scales the attack time of EG8 and the Amp EG. It
interacts with CC# 73.
MOD-7: Tone Adjust Common Tone Adjust parameters
VPM Osc 1–6 Ratio
VPM Osc 1–6 Output Level
Filter A Filter B
Cutoff Cutoff
Macro Macro
Brightness Timbre
Filter/Amp EG Decay Time.
(–99...+99, CC#75)
This scales the decay time of EG8 and the Amp EG. It
interacts with CC# 75.
Filter/Amp EG Sustain Level.
(–99...+99, CC#70)
This scales the sustain levels of EG8 and the Amp EG. It
interacts with CC# 70.
Filter/Amp EG Release Time.
(–99...+99, CC#72)
This scales the release time of EG8 and the Amp EG. It
interacts with CC# 72.
Filter EG Attack Time, Decay Time, Sustain Level, and
Release Time apply to EG8.
Pitch EG Attack Time, Decay Time, Sustain Level, and
Release Time are not supported by the MOD-7.
Button 7, 8:
LFO 1 & 2 Stop
Macro
Feedback
345