017: St. Vintage/Custom Wah - Korg NAUTILUS Series Parameter Manual

017: St. Vintage/Custom Wah

This effect models the tonal character of a vintage wah
pedal. You can customize the tone and range settings.
Stereo In - Stereo Out
Left
Envelope Sens
+
Response
D -mod
LFO
Right
CONTROL
Sweep Mode
Selects the control from auto-wah, modulation source, and
LFO. For more information, see "Sweep Mode" on
page 778.
Source
Selects the modulation source for the wah when Sweep
Mode is set to Dmod.
Manual
Sets the center frequency when Sweep Mode is set to Dmod
and Source is set to Off.
Response
Sets the speed of response when Sweep Mode is set to Auto
or Dmod.
Envelope Sens
Sets the auto-wah sensitivity.
LFO
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
Source
This selects a modulation source for the Frequency.
Amount
This sets the Frequency modulation amount, in Hz.
MIDI/Tempo Sync
BPM
Base Note
Times
When MIDI/Tempo Sync is On, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see "MIDI/Tempo Sync" on page 779.
Type [Individual, Common1, Common2]
This controls whether the effect uses its individual LFO, or
one of the Common FX LFOs. For more information, see
"LFO Type" on page 779.
780
Wah
Sweep Mode
Shape / Invert
Auto
Mode
D-mod
Preset Setting
LFO
Custom Parameters
Wah
[Auto, Dmod, LFO]
[Off...Tempo]
[0...100]
[0...100]
[0...100]
[0.02...20.00]
[Off...Tempo]
[–20.00...+20.00]
[Check-box]
[MIDI, 40.00...300.00]
[x1...x32]
Common LFO Phase Offset [degrees]
When Type is set to Common FX LFO 1 or 2, this lets you
offset the phase from the master LFO.
Wet / Dry
WAH
Mode
Selects either preset or custom settings.
Frequency Bottom
Wet / Dry
Sets the lower limit of the wah center frequency when Mode
is set to Custom. p.779.
Frequency Top
Sets the upper limit of the wah center frequency when Mode
is set to Custom. p.779.
Resonance Bottom
Sets the lower limit of resonance amount when Mode is set
to Custom.
Resonance Top
Sets the upper limit of resonance amount when Mode is set
to Custom.
Shape
This parameter specifies the sweep curve of the wah. It
applies to all control via auto-wah, Dmod, and LFO, and lets
you adjust subtle nuances of the wah effect.
Invert
Inverts the polarity of the sweep.
Output Level
Sets the output level of the effect sound.
Source
Selects the modulation source that will control the effect
output level.
Amount
Sets the modulation amount of the effect output level.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.
[ ... ]
[+/–180]
[Preset, Custom]
[0...100]
[0...100]
[0...100]
[0...100]
[+/–100]
[Check-box]
[0...100]
[Off...Tempo]
[+/–100]