Table of Contents
Advertisement
COMBINATION mode
Timbre 01
X-Y Assign
This assigns an axis of the
volume. See the diagram "X-Y Assign and Program
Volume," below, for more details.
Off means that the X-Y position will not affect the Timbre's
volume.
X-Y Assign and Program Volume
+X
Program volume increases
from left to right.
0%
–127
0
+Y
Program volume increases
from bottom to top.
+127
100%
0
0%
–127
Center Volume
This sets the volume of Timbre 1 at the center point. It
applies only when Equal Amount, above, is set to Off.
The volumes at the extreme ends of the axis are fixed,
depending on the setting of the X-Y Assign parameter.
For instance, if X-Y Assign is set to –X, the Timbre will
always be at 100% volume on the left side, and 0% (silent)
on the right side.
This parameter applies only to the Combi X-Y Volume
control, and does not change the Program's individual X-Y
Volume settings.
400
[Off, +X, –X, +Y, –Y]
Vector
to control the Timbre's
–X
Program volume increases
from right to left.
100%
100%
+127
–127
0
–Y
Program volume increases
from top to bottom.
+127
0%
0
100%
–127
[0, 25, 50, 75, 100%]
Timbre Center Volume, X-Y Assign = –X
100%
Volume 50%
0%
-127
Center Volume Values:
0%
Enable Program X-Y Volume
When this is turned On, the Program's X-Y Volume control
+127
will function as it does in PROGRAM mode, crossfading
between Oscillators 1 and 2. The crossfade will be controlled
by the Program's X-Y Envelope and is not affected by the
Combi's X-Y Envelope.
When this is turned Off, the Program's X-Y Volume control
will be disabled.
Volume at Show Point [%]
Shows the volume at the current X-Y point selected in
"Show Point".
Timbres 02–16
The parameters for Timbres 2–16 are identical to those for
Timbre 01, as described above.
v 1–5: Page Menu Commands
• Compare →p.112
• Write Combination →p.433
• Exclusive Solo →p.113
• Copy From Program →p.433
• PAGE →p.126
• MODE →p.126
0
+127
X-Y X-axis position
100
75
50
25
0
[Off, On]
Advertisement
Table of Contents
