Table of Contents
Advertisement
EXi: AL-1 Analog Synthesizer
EXi PROGRAM > Home
0–1: Overview
0–1b
This is the main page of PROGRAM mode. For a full
description of this page and all of its functions, please see
"EXi PROGRAM > Home" on page 127. This section
describes only the overview display, which differs for each
individual EXi.
0–1b: Overview and Page Jump
This part of the page shows an overview of the most
important settings for the Program's two EXi instruments.
The specific parameters will vary, depending on which EXi
are being used. The specific parameters for the AL-1 are
described below.
The graphics give you a quick way to check all of these
settings at a glance. They also let you jump instantly to any
of the displayed parameters. Just touch one of the graphics,
and you'll jump to the page containing its parameters. For
instance, if you touch the Filter EG graphic, you'll go to the
Filter EG page.
Tip: Pressing EXIT several times will always bring you back
to this page.
Oscillators
This shows the waveforms selected for OSC1, OSC2, and
the Sub Oscillator. It also shows the level and balance
settings for the three Oscillators, plus the Ring Modulator
and Noise Generator. Levels are shown in red, and balance
settings in green.
Press this area to jump to the OSC Basic page. For more
information, see "4–1: OSC Basic" on page 144.
142
Common Key Zone
This shows the key zones for EXi1 and EXi2, as set on the
Common section's Program Basic page, in relation to the
entire MIDI note range. The range of the 61-, 73-, or 88-note
keyboard is also shown, as appropriate.
Press this area to jump to the PROGRAM (Common) >
Basic/X-Y/Controllers– Program Basic page.
Pitch
This shows the Pitch EG Select and Pitch LFO Select
settings for OSC1 and OSC2.
Touch an EG icon to jump to the Pitch EG/Mod page, or
touch an LFO icon to jump to the PROGRAM > AL-1:
OSC/Pitch– Pitch Common, Pitch EG/Mod page.
Filter
Filter Routing & Type
Displays the filter routing and type.
Press this area to jump to the PROGRAM > AL-1: FIlter-
Basic page.
Filter Graphic
Displays the cutoff frequency.
Press this part of the display to jump to the PROGRAM >
AL-1: Filter– Basic page.
EG, LFO
Shows the EG and LFO currently used.
Press this part of the display to jump to the PROGRAM >
AL-1: Filter– Filter Mod., Filter LFO Mod. page.
0–1PMC
0–1d
Advertisement
Table of Contents
