038: Mic Modeling +Preamp; 039: St. Mic Modeling +Preamp - Korg NAUTILUS Series Parameter Manual

038: Mic Modeling +PreAmp

This effect simulates a mic and vacuum tube preamp. You
can choose from various types of mic and positions to create
differing sonic characters.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
+
Mic Simulation
Right
MIC SIMULATOR
Type [Vnt.Dy/55SH, Mlt.Cn/C414, Pc.Cn/C451,
Whale/MD421, Vo.Dy/SM58, Mlt.Dy/SM57,
Vo.Cn/U87, Vo.Tube/U47, BDr.Dy/RE20]
Selects the type of mic.
Position
This expresses the effect that the mic position has on the
sound. The Close setting is the closest mic position, and the
Far setting is the farthest.
TUBE PREAMP
Low Cut [Hz]
Sets the frequency of the low cut filter.
High Cut [Hz]
Sets the frequency of the high cut filter.
Gain [dB]
Sets the input gain to the vacuum tube preamp.
Saturation [%]
Sets the input/output response of the preamp.

039: St. Mic Modeling +PreAmp

Stereo In - Stereo Out
Left
Mic Simulation
Mic Simulation
Right
This is similar to "038: Mic Modeling +PreAmp", but in
stereo. For example, you might use this to simulate micing
of a stereo source such as a rotary speaker.
For more information, see "038: Mic Modeling +PreAmp"
on page 798.
798
Wet / Dry
Tube Pre Amp
Output Level
Wet / Dry
[Close, On, Off, Far]
[Thru, 21...8.00k]
[53...20.00k, Thru]
[–24.0...+24.0]
[0...100]
Wet / Dry
Tube Pre Amp
Output Level
Tube Pre Amp
Wet / Dry
At higher settings, the waveform will change at high gain
levels, tending to cause distortion. Lower settings will
produce linear response.
Mic/Pre Amp - Saturation
Out
Saturation = 0
Saturation = 50
Saturation = 100
In
Bias = 0
Bias
This expresses the effect that changes in vacuum tube bias
have on the distortion of the waveform. Higher settings of
this value will produce distortion even at low gain levels.
Since this will also change the overtone structure, you can
use it to control the tonal character.
Out
Bias = 100
Bias = 50
Bias = 0
In
Satulation = 50
Output Level [dB]
Sets the output level of the preamp.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.
[0...100]
Mic/Pre Amp - Bias
[–48.0...+0.0]