066: Stereo Frequency Shifter - Korg NAUTILUS Series Parameter Manual

OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.

066: Stereo Frequency Shifter

This is a stereo effect that shifts the frequency of the input
signal. You can use LFO modulation and delay to produce a
wide range of pitch-change effects.
Stereo In - Stereo Out
Left
Feedback
High Damp HPF
High Damp HPF
Feedback
Right
FREQUENCY SHIFTER
High Damp [%]
Sets the high-frequency attenuation of the delayed sound.
HPF Fc [Hz]
Sets the cutoff frequency for the high pass filter.
Frequency Shift [Hz]
Sets the amount of frequency shift.
Source
Selects the modulation source that will control frequency
shift.
Amount
Sets the modulation amount for controlling frequency shift.
LFO Depth [Hz]
Sets the depth by which the LFO will modulate the
frequency shift.
Source
Selects the modulation source that will control LFO
modulation of frequency shift.
Amount
Sets the amount by which the modulation source will control
LFO modulation of the frequency shift.
LFO
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
Source
This selects a modulation source for the Frequency.
Amount
This sets the Frequency modulation amount, in Hz.
822
Post-Delay
Frequency Shifter Delay
Pre-Delay
LFO
Output Select
Frequency Shifter Delay
[20...11.90k]
[–6.00k...+6.00k]
[Off...Tempo]
[–6.00k...+6.00k]
[–6.00k...+6.00k]
[Off...Tempo]
[–6.00k...] +6.00k
[0.02...20.00]
[Off...Tempo]
[–20.00...+20.00]
MIDI/Tempo Sync
BPM
Base Note
Times
Wet / Dry
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see "MIDI/Tempo Sync" on page 779.
Type
This controls whether the effect uses its individual LFO, or
Wet / Dry
one of the Common FX LFOs. For more information, see
"LFO Type" on page 779.
Common LFO Phase Offset [degrees]
[0...99]
When Type is set to Common FX LFO 1 or 2, this lets you
offset the phase from the master LFO.
DELAY
Delay Time [msec]
Sets the delay time.
Feedback
Sets the feedback amount.
Source
Selects the modulation source of feedback amount.
Amount
Sets the depth by which feedback amount will be modulated.
Output Select
Selects whether the pre-delay or the post-delay sound will be
output.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.
[Check-box]
[MIDI, 40.00...300.00]
[Individual, Common1, Common2]
[0.0...2730.0]
[Off...Tempo]
[pre-delay, post-delay]
[ ... ]
[x1...x32]
[+/–180]
[+/–100]
[+/–100]