Korg NAUTILUS Series Parameter Manual page 205

To put it another way, setting the Level to Soft makes the
drawbars louder.
This parameter controls the difference in drawbar volume
between the Soft and Loud Percussion settings.
6–1c: Decay
Decay
This toggles the Percussion Decay time between Slow and
Fast. The actual decay times are determined by the Fast
Decay Time and Slow Decay Time parameters, below.
AMS
This selects an AMS source to switch the Percussion Decay
time between Slow and Fast. For a list of AMS sources, see
"Alternate Modulation Source (AMS) List" on page 901.
AMS Mode
This determines the behavior of the Decay AMS. For details,
see "AMS Mode" on page 189.
Fast Decay Time
This sets the decay time when the Decay parameter is set to
Fast.
Slow Decay Time
This sets the decay time when the Decay parameter is set to
Slow.
6–1d: Harmonic
Harmonic
This selects the pitch of the percussion, in harmonics relative
to the 8' drawbar.
2nd produces the same pitch as the 4' drawbar - one octave
higher than the 8'.
3rd produces the same pitch as the 2 2/3' drawbar - one
octave and a fifth higher than the 8'.
AMS
This selects an AMS source to switch the Harmonic between
2nd and 3rd. For a list of AMS sources, see "Alternate
Modulation Source (AMS) List" on page 901.
AMS Mode
This determines the behavior of the Harmonic AMS. For
details, see "AMS Mode" on page 189.
v 6–1: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
• PAGE →p.126
• MODE →p.126
[Slow, Fast]
[List of AMS Sources]
[Toggle, Momentary]
[00...99]
[00...99]
[2nd, 3rd]
[List of AMS Sources]
[Toggle, Momentary]
PROGRAM > CX-3: Percussion 6–1: Percussion
195