085: Tape Echo - Korg NAUTILUS Series Parameter Manual

085: Tape Echo

This effect models a tape echo unit with three playback
heads, including the distortion and tonal changes typical of
magnetic tape.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
Feedback
Feedback Amt
+
Tape
Saturation
Trim Pre Tone High / Low Damp
Wah Flatter
Right
D -mod
Delay Time
INPUT
Trim
Sets the input gain.
Pre Tone
This models the reduced high frequencies of an analog tape
delay, before the saturation stage. Lower settings create a
darker tone.
WOW & FLUTTER
This section models the instability of the tape machine's
motors. As the speed of the motor fluctuates, the pitch
changes slightly. This introduces a pleasant chorus-like
effect.
Frequency [Hz]
Sets the frequency at which pitch variation occurs.
Depth
Sets the depth of the pitch change.
TAPE ECHO
Delay Time
Delay Time(Tap1) [msec]
This parameter sets the delay time of Tap 1.
Also, Taps 2 and 3 are specified as a percentage (%) of this
delay time. Taps 2 and 3 always stay in proportion to Tap 1,
even when the delay time is modulated.
Source
Selects the modulation source for the delay time.
Amount
Sets the modulation amount for the delay time.
Tap2 Position [%]
Sets the delay time of Tap 2, as a percentage of Tap 1's delay
time.
Tap3 Position [%]
Sets the delay time of Tap 3, as a percentage of Tap 1's delay
time.
Wet / Dry
(3)
(2)
(1)
Level Pan
Delay
Tap2/3
Position
Wet / Dry
[0...100]
[0...100]
[0.02...1.00]
[0...100]
[0...2700]
[Off...Tempo]
[–2700...] +2700
[0...100]
[0...100]
Level and Pan 1...3
Each tap has its own controls for level and pan.
Tap1...3 Level
Sets the tap's output level.
Pan
Sets the tap's stereo position.
Feedback
Tap1...3 Feedback Amount
Sets the individual tap's feedback level. Negative values
invert the phase. These individual levels are summed
together, and then the final level is controlled by Feedback
Level, below.
Feedback Level
Sets the overall level of feedback.
Source
Selects the modulation source for the Feedback Level.
Amount
Sets the modulation amount for the Feedback Level.
Tone
High Damp [%]
This cuts the high frequencies in both the main output and
the feedback. Higher settings create a darker tone.
Low Damp [%]
This cuts the low frequencies in both the main output and the
feedback. Higher settings mean less low-end.
Saturation
This models the distortion of an analog tape delay.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.
Delay 085: Tape Echo
[0...100]
[L, 1...99, R]
[+/–100]
[0...100]
[Off...Tempo]
[+/–100]
[0...100]
[0...100]
[0...100]
839