090: Sequence Bpm Delay - Korg NAUTILUS Series Parameter Manual

090: Sequence BPM Delay

This four-tap tempo delay includes a selection of patterns in
16th notes and dotted 8th notes.
Wet: Mono In - Stereo Out / Dry: Stereo In -Stereo Out
Left
Input Level D-mod
+
High Damp Low Damp
Input Level D-mod
Right
Tempo
BPM
Rythm Pattern
INPUT
Input Level Dmod [%]
Sets the modulation amount of the input level. p.823.
Source
Selects the modulation source for the input level. p.823.
DELAY
BPM
MIDI syncs to the system tempo; 40-240 sets the tempo
manually for this individual effect. p.844.
When BPM is set to MIDI, the minimum tempo is 44BPM.
Rhythm Pattern
This parameter automatically creates rhythmic patterns by
controlling the tap delay times and turning individual taps on
and off. You can customize the patterns by using the
feedback amount and per-tap pan controls, below.
The feedback time is always a quarter-note.
Tap1 Pan
Sets the panning of Tap1.
Tap2 Pan
Sets the panning of Tap2.
Tap3 Pan
Sets the panning of Tap3.
Tap4 Pan
Sets the panning of Tap4.
Feedback
Sets the feedback amount. Negative values invert the phase.
Source
Selects a Dmod source to modulate Feedback.
Amount
Sets the modulation amount for Feedback.
844
Pan
Delay
Feedback
BPM
[Off...Tempo]
[MIDI, 40.00...300.00]
[ ...
[L, 1...99, R]
[L, 1...99, R]
[L, 1...99, R]
[L, 1...99, R]
[Off...Tempo]
High Damp [%]
Sets the amount of high-frequency attenuation for the
feedback path.
Low Damp [%]
Wet / Dry
Sets the amount of low-frequency damping for the feedback
path.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
Wet / Dry
"OUTPUT" on page 762.
[+/–100]
3]
[+/–100]
[+/–100]
[0...100]
[0...100]