028: Od/Hypergain Wah - Korg NAUTILUS Series Parameter Manual

OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.

028: OD/HyperGain Wah

This distortion effect has two modes: overdrive and hyper-
gain that produces a strong distortion. A higher high-gain
setting is required for this effect relative to a normal-size
effect.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Mode: Overdrive / Hyper-Gain
Drive
Pre Low-cut
+
Wah Driver
Output Level
Direct Mix
Right
D -mod
WAH
Wah Switch
Source
Mode
These parameters let you turn the Wah on and off from either
the LCD or a controller, and determine how the controller
works. For more information, see "Wah Switch" on
page 790.
Sweep Range
Source
These parameters set the modulation source and amount for
the Wah. For more information, see "Wah Sweep" on
page 790.
DRIVE
Pre Low-cut
This attenuates low frequencies before the signal enters the
distortion. Use this to create a sharper tone.
Drive Mode
Switches between overdrive and hyper-gain mode.
Drive
Sets the degree of distortion. For more information, see
"DRIVE" on page 790.
Direct Mix
Amount of the dry sound mixed to the distortion.
Speaker Simulation
Speaker simulation on/off.
Output Level
Sets the output level. For more information, see "DRIVE"
on page 791.
Overdrive, Amp models, and Mic models 028: OD/HyperGain Wah
Wet / Dry
3 Band EQ
Amp Simulation
Wet / Dry
[Off, On]
[Off...Tempo]
[Toggle, Moment]
[–10...+10]
[Off...Tempo]
[0...10]
[Overdrive, Hyper-Gain]
[1...120]
[0...50]
[Check-box]
[0...50]
Source
Selects the modulation source for the output level.
Amount
Sets the modulation amount of the output level.
EQ
Low Fc [Hz]
Sets the center frequency for Low EQ (shelving type).
Gain [dB]
Sets the gain of the Low EQ.
Mid1 Fc [Hz]
Sets the center frequency for Mid/High EQ 1 (peaking type).
Q
Sets the band width of Mid/High EQ 1. See "Q" on
page 774.
Gain [dB]
Sets the gain of Mid/High EQ 1.
Mid2 Fc [Hz]
Sets the center frequency for Mid/High EQ 2 (peaking type).
Q
Sets the band width of Mid/High EQ 2.
Gain [dB]
Sets the gain of Mid/High EQ 2.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 762.
[Off...Tempo]
[–50...+50]
[20...1.00k]
[–18...+18]
[300...10.00k]
[0.5...10.0]
[–18...+18]
[500...20.00k]
[0.5...10.0]
[–18...+18]
791