Er/Delay - Korg Pa50 User Manual

202 Effects

ER/Delay

ER/DELAY
Early reflection and delay effects
041: Early Refl
(Early Reflections)
This effect is only the early reflection part of a reverberation
sound, and adds presence to the sound. You can select one of
the four decay curves.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
EQ Trim
LEQ HEQ
+
Pre Delay
EQ Trim
Right
Type
a
Selects the decay curve for the early reflection
ER Time [msec]
b
Sets the time length of early reflection
Pre Delay [msec]
c
Sets the time taken from the original sound to the first early reflection
EQ Trim
d
Sets the input level of EQ applied to the effect sound
Pre LEQ Gain [dB]
Table , "Sets the gain of Low EQ," on page 176
e
Pre HEQ Gain [dB]
Table , "Sets the gain of High EQ," on page 176
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 175
Src
f
Table , "Selects the modulation source of the effect balance," on page 175
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 175
a: Type
This parameter selects the decay curve for the early reflec-
tion.
Sharp
Loose
Modulated
Reverse
Dry
Pre Delay
Wet / Dry
Early Reflections
Wet / Dry
Sharp, Loose, Modulated, Reverse
10...800msec
0...200msec
0...100
–15.0...+15.0dB
–15.0...+15.0dB
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Early Reflections - Type
ER Time
042: AutoReverse
(Auto Reverse)
This effect records the input signal and automatically plays it
in reverse (the effect is similar to a tape reverse sound).
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
+
Auto Reverse
Rec/Reverse Play
Right
D-mod
D -mod
Envelope Control
Input
Envelope Select
Rec Mode
a
Sets the recording mode
Reverse Time [msec]
b
Sets the maximum duration of the reverse playback
Envelope Select
Selects whether the start and end of recording is controlled via the modula-
tion source or the input signal level
c
Src
Selects the modulation source that controls recording when Envelope
Select is set to D-mod
Threshold
d Sets the recording start level when Envelope Select is set to Input
Response
e
Sets the speed of the response to the end of recording
Direct Mix
f
Selects how a dry sound is mixed
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 175
Src
g
Table , "Selects the modulation source of the effect balance," on page 175
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 175
a: Rec Mode, b: Reverse Time
When "Rec Mode" is set to Single, you can set up to
1320msec for "Reverse Time. "If recording starts during
the reverse playback, the playback will be interrupted.
When "Rec Mode" is set to Multi, you can make another
recording during the reverse playback. However, the max-
imum Reverse Time is limited to 660msec.
If you wish to record a phrase or rhythm pattern, set "Rec
Mode" to Single. If you record only one note, set "Rec
Mode" to Multi.
The "Reverse Time" parameter specifies the maximum
duration of the reverse playback. The part in excess of this
limit will not be played in reverse. If you wish to add short
pieces of the reverse playback of single notes, make the
"Reverse Time" shorter.
Rec Reverse Rec
Input
Rec Mode = Single
Rec Mode = Multi
Reverse Time
Wet / Dry
Direct
Mix
Control
Wet / Dry
Single, Multi
20...1320msec
D-mod, Input
,
Off...Tempo
0...100
0...100
Fx:031
Always On, Always Off, Cross Fade
Fx:031
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Rec Mode/Reverse Time
Reverse
Envelope Select = Input
Time
Reverse Time