Table of Contents
Advertisement
Data
1. Assembling the ST-550
Stand
Caution
Two or more people are required to assemble
the piano unit.When attaching the piano to
the stand, be careful not to or let go of it.
Make sure you do not mistaken the type or
direction of each part. Follow the assembly
procedures carefully during assembly.If too
much force is applied to the front of the piano
before fastening it with the mounting screws,
the piano unit could fall off the stand.
1.You will need a Phillips head screw driver to
tighten the screws.
2.Open the case and take out the parts.
Remove two pieces of styrofoam packing
material from the box, and place the instru-
ment on them.Place the styrofoam so as to
protect the power cable located on the
underside of the instrument.
・Power cable
・Styrofoam
3.Make sure all the parts shown below are
included in the case.
•Piano Unit
•Rear Panel 4
•Side Panel
(Left) 1
•Pedal Box 3
• Packed in a vinyl bag
• Assembly Screws x 4 5
• Adjuster 6
(M6 x 75)
• Piano Mounting Screws x 4 8
•Side Panel
(Right) 2
• Screws x 10 7
(3.5 x 20)
• Cord Holder x 2 9
4.For assembly, you must place the back of the
stand on a smooth surface such as the floor,
as shown in the diagram below.
Assemble the Side Panel (Left) 1 1 1 1 1 and the
Side Panel (Right) 2 2 2 2 2 to the Pedal Box 3 3 3 3 3
using the 4 assembly screws 5 5 5 5 5 .
•
Screw the Adjuster 6 into the Pedal
Box 3 until it is all the way in.
3
1
5
5.Attach 4 Screws 7 7 7 7 7 in the Pedal Box 3 3 3 3 3 as
shown, tightening them only partially.
7
6.Assemble the Rear Panel 4 4 4 4 4 .
Tighten the Screws 7 7 7 7 7 from the previous step
into the bottom of the Rear Panel 4 4 4 4 4 . Fasten
the Side Panels to the Rear Panel 4 4 4 4 4 using
the 6 remaining Screws 7 7 7 7 7 .
• Install the Rear Panel with
the decorator surface facing
toward the front.
• Fasten the piano cord with the Cord Holders 9.
2
•
Pull out the Pedal Cord.
3
• About 8 mm.
• Do not tighten these
screws until the last.
7
4
• Insert the Rear Panel 4.
Advertisement
Table of Contents
