Assembling The St-9600Ci Stand - Korg Ci-9600 Owner's Manual

Assembling the ST-9600Ci
stand
Caution
• Use two or more people to place the piano on
the stand.
• When placing the piano on the stand, be care-
ful not to pinch your hand.
• Be sure that the correct parts are assembled in
the correct orientation, and follow the steps in
the order that they are given.
• If you apply weight to the front edge of the
piano before tightening the screws, the piano
may fall down.
1. Open the packing carton and remove the con-
tents.
Check that all of the following items are
present.
You will need a "+" (Philips) screwdriver to
assemble the stand.
1
• Side panel (left) • Back panel
• Decorative panel B
• Pedal box
• In the plastic bag
5 6
✕4 ✕1˜
• Long screws • Adjuster
˜
(M6 x 60)
8
✕4
• Longues vis
(M4 x 10)
0
✕4
• Adjustable bolts
2. Attach the side panel (left) 1 and side panel
(right) 2 to the pedal box 3 , and use four long
screws 5 to fasten them.
2
4 ˜
• Side panel(right)
• Decorative panel B
˜ 3
7
✕4
• Short screws
(M3.5 x 16)
9
✕4
• Longues vis
(M4 x 25)
A
✕1
• Cable holder
• Screw the adjuster 6 all the way into
the pedal box 3.
3
1
• Pull out the pedal cable.
5
3. Attach the back panel 4 .
Use four wood screws 7 to fasten the bottom
edge of the back panel 4 , and four medium
screws 8 to fasten the sides.
Use one wood screw 7 to fasten the cable
holder A to the back panel.
• Finished surface toward the front.
• Fasten the cable holder A together with the back panel.
• At this time, make sure that there are no gaps
in the stand, and that it does not tilt.
4. Attach the piano.
Place the piano on the stand so that the plastic
feet on the bottom of the piano fit into the holes
in the side panel brackets. From below, use four
adjustable bolts 0 to fasten the piano to the
stand.
2
8
4
7
0
93