Assembling The St-1500 - Korg Concert C-1500 Owner's Manual

Assembling the ST-1500

Caution
Use two or more people to assemble the stand.
When placing the piano on the stand, be careful not to
pinch your hand. Be sure that the correct parts are as-
sembled in the correct orientation, and follow the steps
in the order that they are given.
If you apply weight to the front edge of the piano before
tightening the screws, the piano may fall down.
1. Open the packing carton and remove the contents.
Check that all of the following items are present. You
will need a Phillips head screw driver to tighten the
screws.
Piano unit
Side Panel
Rear Panel
(Left)
1
Pedal Box
In the plastic bag
• Long screws 5 ✕ 4
• Adjuster 6
(M6 x 16)
• Adjustable bolts 8 ✕ 2
Side Panel
4
(Right)
2
3
• Short screws 7 ✕ 8
(M3.5 x 16)
• Cable holder 9 ✕ 2
2. Attach the side panel (left) 1 and side panel (right)
2 to the pedal box 3, and use four long screws 5
to fasten them.
5
3
1
• Screw the Adjuster 6 into the
Pedal Box 3 until it is all the way in.
3. Attach the back panel 4.
First, use screws 7 to fasten the bottom of the back
panel 4 (at three locations). Then use screws 7 to fas-
ten the side panels (two locations on each side). At this
time, use one screw 7 (either A or B as appropriate for
the location of installation) to fasten the cable holder 9
together with the panel, so that it can be used to hold
the power supply cable.To hold the pedal cable, use
one screw 7 to fasten the cable holder 9 together with
the panel.
• Finished surface toward the front.
• Fasten the cable holder 9
together with the back panel.
B
G At this time, make sure that there are no gaps in the
stand, and that it does not tilt.
2
• Pull out the
Pedal Cord.
7
A
4
7
• A or B to fasten the cable holder
9 together with the panel.
9