Dynamics (Dynamic); 000: No Effect; 001: Stereo Compressor; 002: Stereo Limiter - Korg M3 Parameter Manual

Dynamics (Dynamic)

000: No Effect

Select this option when you do not use any effects. The
Insert Effect/Total Effect section outputs unprocessed
signals and the Master Effect section mutes the output.

001: Stereo Compressor

This effect compresses the input signal to regulate the level
and give a "punchy" effect. It is useful for guitar, piano, and
drum sounds. This is a stereo compressor. You can link left
and right channels, or use each channel separately.
Stereo In - Stereo Out
Left
EQ Trim
LEQ HEQ
Envelope - Control
Envelope Select
Envelope - Control
EQ Trim LEQ HEQ
Right
L/R Mix,
Envelope
a L/R Individ-
Select
ually
b Sensitivity 1...100
c Attack 1...100
d EQ Trim 0...100
Low,
Pre LEQ Fc
Mid-Low
e
High,
Pre HEQ Fc
Mid-High
Pre LEQ Gain
–15.0...+15.0 Sets the gain of the Low EQ
[dB]
f
Pre HEQ Gain
–15.0...+15.0 Sets the gain of the High EQ
[dB]
Output Level 0...100
g Src Off...Tempo
Amt –100...+100
Dry, 1 : 99...
Wet/Dry
99 : 1, Wet
h Src Off...Tempo
Amt –100...+100
a: Envelope Select
This parameter selects whether the left and right channels
are linked to control both signals simultaneously, or whether
each channel is controlled independently.
b: Sensitivity
g: Output Level
The Sensitivity parameter sets the sensitivity of the
compressor. If this parameter is set to a higher value, lower
level sounds will be boosted. With a higher Sensitivity, the
overall volume level is higher. To adjust the final volume
level, use the Output Level parameter.
Wet / Dry
Compressor
Output Level
Output Level
Compressor
Wet / Dry
Determines whether the left
and right channels are linked or
used separately p.441
Sets the sensitivity p.441
Sets the attack level p.441
Sets the EQ input level
Selects the cutoff frequency
(low or mid-low) of the low-
range equalizer
Selects the cutoff frequency
(high or mid-high) of the high-
range equalizer
Sets the output level of the
compressor p.441
Selects the modulation source
for the compressor output level
Sets the modulation amount
for the compressor output level
Sets the balance between the
effect and the dry input
Selects a modulation source for
Wet/Dry
Sets the modulation amount
for Wet/Dry
Level
Wet
Dry
c: Attack
This parameter controls the attack level.
Level
Attack=80
Attack=20
Dry

002: Stereo Limiter

The Limiter regulates the input signal level. It is similar to
the Compressor, except that the Limiter compresses only
signals that exceed the specified level to lower unnecessary
peak signals. The Limiter applies a peaking-type EQ to the
trigger signal (which controls the degree of the Limiter
effect), allowing you to set any band width to be covered.
This effect is a stereo limiter. You can link left and right
channels, or use each channel individually.
Stereo In - Stereo Out
Left
Side PEQ
Envelope - Control
+
Envelope - Control
Envelope Select
Envelope Source
Right
FX Control BUS 1
FX Control BUS 2
Input, Selects the trigger source to
Envelope
FX Control 1, use: the input signal, FX Control
Source
FX Control 2 Bus 1, or FX Control Bus 2 p.442
a
Sets the trigger input level from
FX Ctrl Trim 0...100
FX Control Bus 1/2
Selects from linking both
L/R Mix,
channels, controlling only from
b Envelope L Only, R
left channel, only from the right
Select Only, L/R
channel, or controlling each
Individually
channel individually
1.0 : 1...
Sets the signal compression
c Ratio 50.0 : 1,
ratio
Inf : 1
d Threshold Sets the level above which the
–40...0
[dB] compressor is applied
Attack 1...100 Sets the attack time
e
Release 1...100 Sets the release time
Gain Adjust –Inf,
Sets the output gain
[dB] –38...+24
Selects the modulation source
f Src Off...Tempo
for the output gain
Sets the modulation amount of
Amt –63...+63
the output gain
Side PEQ Toggles between on/off of the
Off, On
Insert trigger signal's EQ
g
Switches between effect
Trigger
Off, On output monitor and trigger
Monitor
signal monitor
Dynamics (Dynamic)
Compressor - Sensitivity
Sensitivity=100
Sensitivity=40
Time
Compressor - Attack
Wet
Time
Wet / Dry
Gain Adjust
Limiter
Trigger Monitor
Limiter
Gain Adjust
Wet / Dry
p.442
p.442
p.442
p.442
p.442
p.442
p.442
p.442
441