Removing The Dust Filter; Removing The Left-Side Cover - Christie DHD410S Service Manual

5. If required, replace the top cover.
6. To re-install the top cover, follow these steps in reverse order.

Removing the dust filter

The two optional filters are on the left of the projector.
1. Power off the projector and unplug the power cord.
2. Pull out the dust filter, as shown in the illustration (1).
3. Carefully remove the dust filter. Then clean or change the filter in illustration (2).
4. To install the filter, reverse the previous steps.

Removing the left-side cover

The left-side of the projector is determined by facing forward from rear of the projector.
1. Remove the top cover.
See
Removing the top cover
DHD410S Service Manual
020-001481-01 Rev. 1 (10-2018)
on page 46.
Projector covers
47