Removing The Left-Side Cover - Christie GS Series Service Manual

3. Remove the ten M3 screws with a Phillips #1 screwdriver securing the rear cover.
4. Disconnect the rear IR board harness.
5. Remove the rear cover from the projector.
6. If required, replace the rear cover.
7. To re-install, follow these steps in reverse order.

Removing the left-side cover

The left side of the projector is determined by facing forward from rear of the projector.
1. Remove the top cover.
See Removing the top cover
2. Remove the rear cover.
See Removing the rear cover
3. Remove the four M3 screws with a Phillips #1 screwdriver.
4. Remove the left-side cover from the projector.
It will still be attached to the cord of the interlock switch.
5. To separate the interlock switch from the left-side cover, remove the two M3 screws with a
Phillips #1 screwdriver.
GS Series 630-635 Service Manual
020-001224-02 Rev. 1 (08-2018)
on page 51.
on page 52.
Projector covers and feet
53