2. Remove the front cover.
See
Removing the front cover
3. Remove the rear cover.
See
Removing the rear cover
4. Loosen the four captive M3 screws.
5. At both ends of the cover, remove the four M3 screws securing the right-side cover module.
6. To separate the right-side cover from fans 1, 2, and 3, remove the 12 M3 screws.
7. Transfer the fans to the new right-side cover.
8. Replace the right-side cover.
9. To re-install, follow these steps in reverse order.
Removing the left-side cover
The left side of the projector is determined by facing forward from rear of the projector.
left-side from the back
1. Remove the top cover.
See
Removing the top cover
2. Remove the front cover.
See
Removing the front cover
3. Remove the rear cover.
See
Removing the rear cover
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
on page 58.
on page 58.
on page 57.
on page 58.
on page 58.
Projector covers and feet
60