Removing the left-side cover
The left-side of the projector is determined by facing forward from rear of the projector.
1. Remove the top cover.
See
Removing the top cover
2. Remove the main board module.
See
Replacing the main board
3. Remove the main board bottom shielding.
See
Removing the rear cover
4. Remove the front cover.
See
Removing the front cover
5. Remove the rear cover.
See
Removing the rear cover
6. Remove the keypad board.
See
Removing the keypad board
7. Remove the filter-L switch.
See
Removing the filter-L switch
8. From the bottom of the left-side cover, remove the seven M3 screws with a Phillips #1
screwdriver securing the cover.
9. Remove the left-side cover from the projector.
10. Transfer the filter-L switch to the new left-side cover.
11. To re-install, follow these steps in reverse order.
Removing the bottom cover
To remove the bottom cover, complete the following steps.
1. Remove all covers from the projector.
HS Series 2K Service Manual—D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001468-02 Rev. 1 (01-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 59.
on page 94.
on page 59.
on page 61.
on page 59.
on page 103.
on page 72.
Projector covers and feet
63