Ae Host Command Set; Table 4-10. Ae Host Commands - Advanced Energy Paramount MF 2 kW User Manual

®
Advanced Energy
Table 4‑9. AE Host command status response (CSR) codes (Continued)
Code
9
12
17
28
30
41
42
50
51
52
61
63
99

AE Host Command Set

• Commands 1 through 127 request a change to the Paramount MF 2 kW unit,
such as changing a setting in the unit. The unit responds to these commands by
sending a command status response (CSR). This single-byte response indicates
whether the unit has accepted or rejected the command and, in the case of
rejection, the reason the unit could not respond to the command.
• Commands 128 through 255 request information from the unit, such as unit
settings. The unit responds to these commands by sending the data requested if
the command was successful, and a CSR if the command was not successful.
Unless otherwise specified for individual commands, AE Bus protocol is little
endian, which means that all values greater than 1 byte are sent least significant byte
first.
Table 4‑10. AE Host commands
Command
1
RF Off
57020114-00E
Command's data byte count is incorrect.
Feature is not available on this unit.
Minimum off time is active.
Set point exceeds user limit.
EEPROM read/write error.
One or more warnings are active.
DHCP is active.
Frequency is out of range.
Duty cycle is out of range.
Minimum on or off time is violated.
Real time clock was busy.
Flash mode is active.
Command not accepted (there is no such command).
Description
Turns RF output off. Accepted regardless of
control mode. This command explicitly clears
all latched faults, but it does not clear any
faults that are currently active.
Command 162 reports this value.
Communication Controls
®
Paramount MF 2 kW Generator
Meaning
Data Bytes
Sent
0
Data
Bytes
Returned
1
4‑20