Table 4-3. 25-Pin User Port Pin Descriptions - Advanced Energy Paramount MF 2 kW User Manual

®
Advanced Energy
Table 4‑2. User port signal descriptions (Continued)
Description
Analog outputs (AO)
Table 4‑3. 25-pin User port pin descriptions
Signal Related
Pin Pin
1 14
2 15
3 16
4 17
57020114-00E
Return wire should be connected to system ground.
Accuracy of voltage measurement: ± 0.6% or ± 20 mV.
The input impedance for all analog input signals is greater than
10 kΩ.
Voltage range 0 V to 10 V
Return wire should be connected to system ground.
Accuracy of voltage measurement: ± 0.6% or ± 15 mV.
The load impedance for all analog output signals should be
greater than 1 kΩ.
Name Signal
Type
SET POINT Digital
STATUS output
RETURN
RFL PWR Analog
MONITOR output
FWD/LOAD Analog
PWR MONITOR output
RF PWR ON Digital
input
Communication Controls
®
Paramount MF 2 kW Generator
Specification
Description
See pin 14.
This signal provides a linearly scaled
readback of reflected power.
• 0 V = 0 W
• 10 V = 1500 W
See Figure 4‑2 on page 4‑6 for the
wiring diagram.
This signal provides a linearly scaled
readback of forward power when the
generator is operated in forward power
regulation mode or the load power when
operated in load power regulation mode.
In voltage control mode, this signal
provides readback of forward power.
• 0 V = 0 W
• 10 V = Maximum rated output
power
See Figure 4‑3 on page 4‑7 for the
wiring diagram.
When logic high is applied to this pin,
RF output is enabled (if generator is in
user control mode). Logic low disables
4‑3